Waterproofing
Deck & Balcony Waterproofing
Waterproof systems for walk decks, roof decks, and balconies with living or finished space below, in Whitefish, Kalispell, Bigfork, and across the Flathead.
A deck over living space is a roof
Any exposed deck or balcony built over finished space is a roof. It just doesn't look like one. The waterproofing under the walking surface is what keeps water off the structural deck, the framing, and the room below.
No room for a leak
A leak here shows up as damage to the ceiling, framing, and finishes underneath. The transitions, edges, drains, and penetrations are where the work is.
The Assembly
How the deck goes together.
Framing, sloped to the edge. Joists pitched so water runs off the deck, away from the house. A finished room sits right under it.
Plywood. Exterior plywood, with every joint landing on a joist or blocking so the seams don't move.
Metal. Drip edge at the outer edge. L-metal at the wall, with its leg running 4 in. up the sheathing, nailed off.
Three-coursed seams. Every plywood seam and both metal flanges get three-coursed: a bead of Poly-Caulk® PX 15GG polyurethane caulk, Straight Jacket mesh tape set into it, and caulk over the top. The top edge of the wall metal gets sealed to the sheathing with the same caulk.
Primer, then PC-260. Polyprime® 2180, a two-part epoxy primer, so the membrane bonds to the plywood and the metal. Then PC-260 pulled out edge to edge with a notched squeegee, over the seams, up the wall metal and onto the drip edge, with sand broadcast into it for grip. That's the waterproofing.
Polyglaze, then the wall closes over. PC-260 can't take sun, so Polyglaze™ 100 goes over it, locks the sand in, and takes the UV and the foot traffic. House wrap and siding come down over the wall metal, so water off the wall lands on the deck and runs off the drip edge.
The Waterproofing System
PC-260 is the membrane.
Ridgeline uses Polycoat PC-260 as the waterproofing membrane in exposed-deck systems. It's the base that keeps water off the structure. The membrane doesn't dictate the finished surface: depending on the assembly, PC-260 can be incorporated beneath finished walking surfaces such as tile or concrete/topping systems, as well as under an exposed wear coat. Primers and topcoats vary with the substrate, the exposure, and the finish.
Substrate → Primer → PC-260 Waterproofing Membrane → Finished Surface / Wear System
Substrate
Plywood, concrete, or existing deck, prepped and detailed at the edges and penetrations.
Primer
Matched to the substrate so the membrane bonds and stays bonded.
PC-260 Membrane
The waterproofing layer itself, continuous across the deck and up the transitions.
Finished Surface / Wear
The walking surface over the membrane: an exposed wear coat, tile, or a concrete/topping system, depending on the assembly.
From the Field
Before, during, after.
Most of a deck system gets covered up once the walking surface goes down. Here's the part that matters, in order, on one balcony in Whitefish. See the full sequence.


